logo

DETAILS

Check category

Busway is installed in an open and visible area to prevent mechanical damage

  • Categories:Zhongrui News
  • Author:
  • Origin:
  • Time of issue:2019-05-28 15:15
  • Views:

(Summary description)Lighting busway The lighting busway has a rated current of up to 60A and a ground voltage of 300V. Use two, three or four wires. It can be used to illuminate special designs with fluorescent lamps and high intensity discharge lamps.

Busway is installed in an open and visible area to prevent mechanical damage

(Summary description)Lighting busway

The lighting busway has a rated current of up to 60A and a ground voltage of 300V. Use two, three or four wires. It can be used to illuminate special designs with fluorescent lamps and high intensity discharge lamps.

  • Categories:Zhongrui News
  • Author:
  • Origin:
  • Time of issue:2019-05-28 15:15
  • Views:
Information
Lighting busway
 
The lighting busway has a rated current of up to 60A and a ground voltage of 300V. Use two, three or four wires. It can be used to illuminate special designs with fluorescent lamps and high intensity discharge lamps.
 
The lighting busway supplies power to the lighting fixture and serves as a mechanical support for the luminaire. A "strengthening rod" can be used as an auxiliary support device. The maximum support spacing of the stiffener is 4m. The fluorescent lamp can be hung on the busway, and the lamp with plug and hook can be ordered to directly mount the lamp on the busway. It is also possible to conceal the busway in the ceiling or on the surface of the greenhouse. The lighting busway is also used to power the power of the light industry.
 
Sliding busway
 
Sliding busbars are used to hold fixed or moving branching devices. Used on active production lines to supply power to motors or hand-held tools that move along the production line, or to the part of the operator that moves back and forth within 5m to complete a specific operation.
 
The busway can only be installed in an open and visible location. It is allowed to be installed behind the power distribution panel if there is a channel and the following conditions are met. Except for a single fixture, no overcurrent devices are installed on the busway. The space behind the disc is not used as an air conditioning space. The busway is completely enclosed and non-vented. The installation of the busway allows the joints and accessories between the sections to be easily serviced. Busbar slots should not be installed where they are subject to severe mechanical damage, corrosive steam or crane loading and unloading. A special device specially manufactured for a purpose, the busway can be installed in a hazardous area, outdoors or in a humid place. The support spacing of the busway should not exceed 10m. For special special devices, the horizontal busbar support spacing can reach 25m, and the vertical busway support spacing can reach 40m.
 
Where the busway is through the floor and the distance from the floor is less than 15m, the busway must be completely enclosed and properly protected to prevent mechanical damage. If the connector is outside the wall, the busway can be routed through the wall.

Scan the QR code to read on your phone

ABOUT US

 

 

Introduction

 

Business

 

Win-win

 

Advantage

 

Contact us

NEWS

 

 

Zhongrui News

 

Industry

 

FAQ

 

Support

 

CONTACT US

Add:92 Weier Road, Chengbei Park, Jingjiang Economic and Technological Development Zone, Jiangsu Province 

Phone

Mobile version